Intelligent charger can charge up to 15 NiMH/NiCD cells in series
May 06, 2011 // Julien Happich
Powersolve the PSCH30 Smart Charger, an intelligent battery charger that can automatically detect and charge 8 to 15 NiMH or NiCD cells, providing the necessary output to fully charge the cells and before it turns itself off. Output voltage, which varies depending on load, is from 9.6 to 18V and output current is from 500mA to 1.8A which can be switched to charge at 0.9 or 1.8A. Safety ground leakage current is below 0.5mA.
The charger features battery temperature monitor with over temperature shutdown. Overvoltage and short circuit protection are standard as is protection against reverse polarity. An LED status indicator confirms standby, charging, fully charged and error states. The PSCH30 features a universal AC input and incorporates an IEC320 C14 3 pin AC input connector. Powersolve can supply a variety of optional DC output connectors to suit specific needs. The charger comes in a 120x60x38mm desk top plastic enclosure and operate in the 0 to 40°C temperature range. It also complies with all relevant international safety standards as well as EMC compliance to EN55022 'B’, CISPR 22 'B’ and FCC Part 15 ’B’.
Visit Powersolve Electronics at www.powersolve.co.uk
Obsolescence groups tackles long term supply and conflict minerals challenges
May 20, 2013
The increasing use of off the shelf commercial equipment and conflict minerals are two key risks facing designers of long ...
First 45nm embedded flash logic test chips sample
Wolfson to move integrated MEMS microphones to 8in wafers
Exploiting depth sensing for 3D interfaces and complex image analysis
Floating surge stopper provides unlimited overvoltage protection
Altera to integrate Enpirion power interfaces into its FPGAs
May 17, 2013
Altera is planning to develop IP blocks for its FPGAs optimized for the Enpirion power management devices following the $141m ...
Automation CAN group plans permanent interoperability test capability
Opening up new user-interaction scenarios with Time-of-Flight measurements
Goepel electronic initiates Cooperation Network with EMS companies
InterviewWireless control drives Atmel in Europe
Atmel's recent acquisition of Osmo Devices with a WiFi Direct design center in Cambridge and some key microcontroller launches has seen the company focus heavily on wireless control in Europe says Jörg ...
Filter WizardCheck out the Filter Wizard Series of articles by Filter Guru Kendall Castor-Perry which provide invaluable practical Analog Design guidelines.
Linear video channel
READER OFFERRead more
The development platform for i.MX 6Quad from element14 (built to the Freescale SABRE Lite design) is an evaluation platform featuring the powerful i.MX 6Q, a multimedia application processor with Quad ARM Cortex-A9 cores at 1.2 GHz from Freescale Semiconductor.
This month, Freescale and element14 are giving away five such platforms, worth £128.06 each, for EETimes Europe's readers to win. The platform helps evaluate the rich set of peripherals and includes a 10/100/Gb Ethernet port, SATA-II, HDMI v1.4, LVDS, parallel RGB interface, touch screen interface, analog headphone/microphone, micro TF and SD card interface, USB, serial port, JTAG, camera interface, and input keys for Android.
And the winners are...
In our previous reader offer, Pico Technology was giving away one of its recently launched PicoScope 3207B, a 2-channel USB 3.0 oscilloscope worth 1451 Euros. Lucky winner Mr L. Sanchez-Gonzalez from Spain should be receiving his PicoScope 3207B soon. Let's wish them some interesting findings with his projects.
December 15, 2011 | Texas instruments | 222901974
Unique Ser/Des technology supports encrypted video and audio content with full duplex bi-directional control channel over a single wire interface.