Power Components Simplify 1kW Power Design
June 04, 2012 // Jeff Ham, Vicor // 0 commentsDownload White Paper 442Ko
Not long ago, designing a 1,000 W power supply for operation on worldwide AC lines was a task for the most experienced power design engineers. Besides dealing with the design of autoranging front-end rectification circuitry and isolated power conversion stages, the designer faced a myriad of other complex technical and design issues: inrush current limiting, sizing and selection of holdup capacitors, transient protection, thermal design, and worldwide safety agency and conducted noise requirements.
Most popular PapersRead more
Advancing the smart factory through technology innovation
September 24, 2014 | Karl-Heinz Steinmetz | 222922466
Flexible Performance for Network Security Appliances
August 30, 2014 | Pomah Yen, Chief Product Manager, CASwell Inc., a Subsidiary of Portwell | 222922199
Building Blocks for the Internet of Things
August 01, 2014 | Kumar Balasubramanian, Intelligent Solutions, Intel® Corporation | 222921947
- Advancing the smart factory through technology innovation
- A Novel Approach to Industrial Rectifier Systems
- Putting FPGAs to Work in Software Radio Systems Handbook
- Smartphone SoC Power Efficiency - DVFS Capacitor Switching
InterviewCEO interview: AMS' Laney on driving a sensor-driven business
Kirk Laney, CEO of Austrian mixed-signal chip and sensor company AMS, wants to leverage the opportunity that technology affords to create new markets for sensors and sensor interfaces.
Filter WizardCheck out the Filter Wizard Series of articles by Filter Guru Kendall Castor-Perry which provide invaluable practical Analog Design guidelines.
Linear video channel
READER OFFERRead more
This month, Trinamic Motion Control is offering you to win one of four TMCM-1043 development kits for its highly integrated, NEMA 17-compatible TMCM-1043 stepDancer stepper motor module.
Offering designers an easy-to-use PC-based GUI that allows one-click modification of motor drive current, micro-stepping and other key parameters, the intuitive kits are custom designed and developed for direct mounting on a NEMA 17 motor. Pre-programmed and pre-configured with all operating parameters to support standard 1.5A (peak) motors, the TMCM-1043 board uses Trinamic´s single-axis TMC2660 stepper motor driver IC, which integrates a motor pre-driver and power MOSFETs.
December 15, 2011 | Texas instruments | 222901974
Unique Ser/Des technology supports encrypted video and audio content with full duplex bi-directional control channel over a single wire interface.