IP67 wire-to-wire and wire-to-board connectors

March 10, 2016 // By Julien Happich
EDAC's new water- and dust-proof wire-to-board and wire-to-PCB connectors from the 560 and 572 Series provide absolute protection against dirt, dust and immersion in water up to 1m depth for up to 30 minutes.

Featuring double latches that providing a tactile double 'click' when fully mated, the E-Seal 560 Series connectors are exceptionally resilient to vibration. The devices offer 2, 3 or 5 contacts in wire-to-wire and wire-to-board variants. The seals, which are pre-assembled within the housings, are available to accommodate 1.0 to 1.3mm and 1.3 to 1.7mm wire thickness. The connectors feature a 2.5mm pin pitch and a current rating of 3A, 250VAC, with an operating temperature range of between -40º and +105º C. Electrical integrity is ensured by internal polarisation, eliminating the possibility of mis-mating the connectors. Wire termination is made with crimp 'poke home'contacts. A waterproof cap seals any unused contact positions. 

Also featuring the same 'peace of mind' double latching as the as the 560 Series, EDAC's E-Seal 572 Series connectors offer 1, 2 or 3 contacts with wire-to-wire and wire-to-board variants. Wire seals, which are assembled onto each wire when crimping the contacts to the cable, are available in a choice of 4 colour coded sizes to accommodate wire diameters from 1.7mm to 3.1mm. 572 Series connectors offer a 5.8mm pitch and a current rating of 10A at 300V AC and are rated for operation within the -40º to +105º C temperature range. Internal polarisation ensures electrical integrity. 

EDAC supports its E-Seal connector customers with a range of application tooling, including hand crimping tools applicators and contact removal tooling.

Visit EDAC Europe at www.edac.net