Information directly from the main stress zone of a manufacturing process are crucial for modern process control systems. Pressure and temperature data along with their associated spatial data make steady process control. To achieve exact data, the sensors must be attached to the workpieces - but this is exactly where typically there is no room available for any sensors. For this reason the Fraunhofer Institute for Surface Engineering and Thin Films (Braunschweig, Germany) has devised an innovative solution: The scientists are coating the machine tools with non-wearing thin-film sensors.
To withstand the abrasive forces in the main stress zones, the piezo and temperature sensors are enclosed into robust hydrocarbon layers. This makes it possible to integrate the sensors directly into tools for injection moulding, sheet metal filling and punching. The basis for these layered sensory systems is a multi-functional hydrocarbon layer, baptized DiaForce which unites abrasive resistance with wear resistance and piezo-resistive behaviour.
To achieve measurements with spatial information, the researchers deposited electrode structures made from chromium o top of the sensors. To prevent wear, these chromium layers are covered with an electrical insulator layer of SiCON, a material made of silicon and oxygen. Optional, an additional meander structure is can be applied to this SiCON layer which would result in local temperature measurement devices. These devices again are protected by a SiCON cover. The entire system represents a layered sensor at an overall thickness of some 9 to 12 micrometres. These layered sensors are attached to carriers shaped according to the respective application; afterwards they are integrated to the machine tool where they measure relevant parameter and transmit the results to a control unit. Thus they provide a significant contribution to understanding and monitoring the process. The measurement provides a significant contribution to process optimisation and can checked against numeric simulation.
The sensor module for use in injection moulding processes is a result of the "Wechselwirkungen" project funded by