UV LEDs: solving the droop issue

January 31, 2017 // By Julien Happich
In a recent paper published in Optics Express, researchers from King Abdullah University of Science and Technology (KAUST) share their novel approach to designing droop-free AlGaN-based UV LEDs.

Often, they note AlGaN-based ultraviolet LEDs suffer from low internal quantum efficiency, low extraction efficiency, inefficient doping, large polarization fields, and high dislocation density epitaxy, all limiting their use at high power.


3D depiction of the UV NWs LED grown
on Ti/Si template substrate.

Starting with a titanium-covered silicon wafer and relying on plasma assisted molecular beam epitaxy (PAMBE), the researchers were able to grow well-separated defect-free Si-doped GaN nanowires, each one embedding a stack of ten uniformly formed AlGaN/AlGaN quantum disks (Qdisks).

While each emitting nanowire was about 8nm in diameter and roughly 350nm long, for practical experimentation, the macroscopic LEDs were made up of whole regions of the densely packed vertically aligned NWs (at a density of roughly 9x109 cm−2).


Structural characterization of the NWs.
(a) Cross section SEM image shows vertically aligned NWs.
(b) Top view SEM image of the device grown on Ti/Si substrate shows tightly packed NWs.
(c) High angle annular dark field scanning transmission electron microscopy (HAADF-STEM) of AlGaN nanowire showing the n-type AlGaN layer, AlGaN/AlGaN QDisks, p-type AlGaN, and p-GaN layer.
(d) Active region is showing 10 pairs of uniform Qdisks formation. (d) Zoomed-in image of the Qdisks show compositional variation across the Qdisks.

The devices were grown on a titanium-coated n-type silicon substrate to improve current injection and heat dissipation, they emitted UV light at 337nm (with a narrow linewidth of 11.7nm) for a current density of 32A/cm2 (80mA in 0.5x0.5mm2 device) with a turn-on voltage of about 5.5V.

The AlGaN nanowire UV LEDs operated droop-free up to 120A/cm2 of injection current.